Aeris swopper STANDART Інструкція з використання Посібник з використання - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з використання Посібник з використання для Внутрішнє оздоблення приміщень Aeris swopper STANDART. Aeris swopper STANDART 20 сторінок.

Друкувати сторінку

How to mount and use the

metal and felt gliders

The "swopper" without rollers is usually supplied with metal

gliders. These are suitable for use on textile-covered floors

(carpet, felt etc.), but never on floors that might become wet or

damp. For smooth floor surfaces (stone, tiles, parquet, cork,

PVC and the like) please use only felt gliders. If these are

not included in the delivery package, we will be glad to send

them to you free of charge.

To change the gliders, carefully turn the "swopper" upside

down and remove the metal gliders using a pipe wrench.

Replace the metal gliders with the felt gliders and press or

tap these firmly into place. That's it!

How to mount and use

the rollers

If you have chosen a "swopper" with rollers, then rollers

braked in compliance with DIN EN 12529 are included in

the delivery package. These universal rollers can be used

on practically any type of floor. Special "Speed" rollers can

also be fitted to the "swopper" for use on very deep pile

carpets or rough floor surfaces.

Please use the enclosed brush-like "swopper" grip when

using your "swopper" on smooth, hard floors (parquet,

Grip

laminate, stone etc.). This prevents unwanted rolling away.

You can easily mount it yourself by exchanging it for the

black rubber cap on the underside of the base ring. Carefully

turn the "swopper" upside down, remove the black rubber

cap on the underside and insert the "swopper" grip in

its place. Now, when you sit on your "swopper" on smooth

floor surfaces, the spring strut makes contact with the

floor for better support. To get the "swopper" rolling you

must slightly lighten the load on the seat.

Settings

You can adjust the "swopper" in three different ways to

meet your individual requirements: height, spring hardness

and sideways movement.

1. Height adjustment

Using the lever under the seat you can adjust the height

continuously. The open angle of your legs (thigh to lower leg)

should be just over 90°. We recommend adjusting the height

of your desk appropriately. If this is not possible, then please

adjust the seat height to achieve an optimum distance

between your eyes and the working surface.

2. Spring hardness

You can set the spring hardness according to your weight and

your personal preference (more or less movement). The optimum

setting is when you can move freely in all directions without

impediment. Set the spring hardness by turning the sleeve on

the spring strut - down for maximum movement or low weight.

Turn the sleeve up for reduced movement or greater weight.

3. Sideways movement

The sideways movement of the "swopper" is decisive for

activating your muscles. The softer the setting, the more you

strengthen your muscles. We recommend starting off with

a setting for reduced sideways movement and then gradually

adjusting the setting to provide as much movement as poss-

ible. For adjustment it is best to turn the "swopper" upside

down and turn the handwheel towards (+) for more sideways

movement and towards (-) for less sideways movement.

4. Backrest

The backrest height is adjustable. To adjust the height,

you press on the button on the inside of the backrest rod.

Move the backrest into the position that is most comfortable

for you and then let the button click into place.