CAME BY-3500T Посібник з швидкого налаштування - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з швидкого налаштування для Відкривач гаражних дверей CAME BY-3500T. CAME BY-3500T 12 сторінок. Complete kit for a sliding gate weighing up to 3500kg / max. width 23m
Також для CAME BY-3500T: Посібник (17 сторінок)
Друкувати сторінку
ZT6:
transmitters
Ensure the AF card is fi tted (refer to the wiring diagram).
add
a transmitter button
Press and hold the CH1 button, the PROG. LED starts fl ashing rapidly.
1.
While keeping the CH1 button held down press and release a button on a transmitter
2.
The PROG. LED goes solid to signal the successful saving of the code.
3.
Release the CH1 key.
One individual button can be saved.
duplicating
a transmitter button
Additional transmitters will need to be duplicated from the one that was saved to the control board
in the above procedure.
Using a transmitter that has not been saved on to the control board
1.
2.
3.
NEW
PROGRAMMED
x3
Should the transmitter not operate as suggested above,
call CAME helpline
Press and hold the two large buttons on the remote until the
LED at the top starts fl ashing rapidly.
Release the buttons.
Now press and release the button you wish to use
to open the gate.
The LED will change to a slow fl ash.
Place the previously programmed transmitter against
the new transmitter.
Press and release the button on the previously saved
transmitter that is used to open the gate.
The LED on the new transmitter will fl ash three times to
acknowledge it has received the signal from the saved transmitter.
0115 921 0430
for technical support.