3Disc Heron IOS Посібник із швидкого старту - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Стоматологічне обладнання 3Disc Heron IOS. 3Disc Heron IOS 12 сторінок.

Bite Alignment Procedure:

The bite alignment procedure will be necessary to align the upper and lower jaws.

This process will only be allowed if lower and upper jaw scans have been previously

conducted. Once the Bite button is pressed, it may take a few seconds to load the

previous scans.

1. Start scanning from the back of the upper buccal area. Move forward and

backwards along the molar and pre-molar area, making sure to scan some

of the gingiva area and to tilt the handpiece upward slightly. When an initial

alignment is found the jaw will be transformed into alignment with the bite

scan. When a final alignment is found the application will "ring" and a green

check mark will appear on the upper jaw image in the upper right corner of the

application.

2. Once the upper jaw is aligned, move the handpiece down to the lower jaw

Again, move the handpiece forward and backwards along the buccal of the

molar and pre-molar areas, making sure to scan some of the gingiva area, and

tilt the handpiece downward slightly. The update process for the lower jaw

is like that of the upper jaw, except when a final alignment is found a green

check mark will appear on the lower jaw image in the upper right corner of the

application.

3. When both jaws have been aligned, pause the scan and review the alignment.

If occlusal between the upper and lower scans is observed, you can choose

to restart the bite alignment process or export the scans to fine tune the

alignment in a third-party application.