Alto 30HA STANDARD I/MASTER I Інструкція з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Мийка високого тиску Alto 30HA STANDARD I/MASTER I. Alto 30HA STANDARD I/MASTER I 19 сторінок. Alto-shaam inc. pressure washer user manual
Також для Alto 30HA STANDARD I/MASTER I: Посібник користувача (19 сторінок)
Друкувати сторінку
4.
Fuel filling
Filling of fuel for the boiler through the filler socket (4). Capacity of tank: 15 l. Only use heating oil or diesel
oil. The fuel level can be read on the level indicator (5).
If the burner stops unintentionally, check the fuel level in the tank and if necessary fill up with fuel (at
least 5 l).
In consideration of the life of the fuel pump it is important that the machine is not allowed to run in hot water
mode without fuel in the fuel tank.
5.
Spray handle - accessories
Pull forward the grey quick coupling trigger of the spray handle (7).
Insert the nipple of the spray lance (9) in the quick coupling and release the trigger.
Pull forward the spray lance or any other accessory to ensure correct mounting before starting the cleaner.
Max. thrust of spray handle and lance - see section "1.2 Technical data".
6.
Detergents - dosing unit
Detergents can be added under low pressure through the built-in dosing system (10). Fill the tank with a
detergent (11). It is possible to pull out the suction hose with filter (12) and place it in a container with deter-
gent. The dosage is infinitely variable (step 0-5), and the required dosage is adjusted by turning the knob
counter-clockwise, until the required step is against the arrow on the control panel. Max. dosing is approxi-
mately 5%. Upon application of the detergent, the system should be flushed through with pure water at step
5 for approximately 1 min., and the knob should be turned clockwise to step 0.
7
9
Operating instructions
Use heating oil or diesel oil.
WARNING! Use of a wrong fuel can be
hazardous!
Capacity of tank: 15 l.
Clean nipple of any impurities each time
the spray lance has been dismounted.
Only use ALTO detergents.
Use of aggressive detergents may
damage equipment and affect the
environment.
Flush with water after use.
GB
7