Alto Wap DX 840 Інструкція з експлуатації Посібник з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Мийка високого тиску Alto Wap DX 840. Alto Wap DX 840 19 сторінок.
Друкувати сторінку
cleaning will not result in
dangerous substances (e.g.
asbestos, oil) being washed
off the object to be cleaned
and harming the environ-
ment.
Do not clean delicate parts
made of rubber, fabric, etc.
with the round jet. Hold the
nozzle at a distance of at
least 15 cm when cleaning
with the high-pressure flat
jet.
Although extremely easy
to operate, children
should not be allowed to
use the cleaner.
Do not use the high-
pressure hose for lifting
loads.
Do not continue to use the
cleaner if the mains power
lead or high-pressure hose is
damaged.
Ensure an adequate air
circulation. Do not cover
the cleaner or operate it in
inadequately ventilated
rooms!
If the overload protection
device trips (motor cuts
out), release the trigger of
the spray gun, insert the
trigger locking device and
turn the ON/OFF switch to
position „O". Allow the
cleaner to cool down for at
least 3 minutes!
6
Store the cleaner where it
will not be exposed to
frost!
Never operate the cleaner
without water. Even brief
shortages of water result
in severe damage to the
pump seals.
The pressure-bearing parts
of this high-pressure
cleaner have been
manufactured in
accordance with § 9 of the
German Pressure Vessels
Ordinance and successfully
subjected to a pressure
test.
OPERATION
Do not damage the mains
power lead (e.g. by driving
over it, pulling or crushing
it).
Remove the plug from the
plug socket directly at the
plug (not by pulling or
tearing at
the mains power lead).
MAINTENANCE AND
REPAIR
CAUTION!
Always remove the plug
from the mains plug
socket before cleaning
or carrying out mainte-
nance work on the
cleaner.
Carry out only the mainte-
nance operations descri-
bed in the operating
instructions.
Use only original Alto
spare parts. Do not make
any technical modificati-
ons to the
high-pressure cleaner.
CAUTION!
High-pressure hoses,
fittings and couplings are
important for the safety of
the cleaner. Use only high-
pressure parts approved by
the manufacturer!
CAUTION!
Failure to observe these
instructions can endanger
your safety.
Please contact the Alto
service department or
an authorised specialist
work-shop for all other
maintenance or repair
work!
ELECTRICAL EQUIPMENT
Check the rated voltage of
the high-pressure cleaner
before connecting it to the
mains power supply. Ensure
that the voltage specified on
the rating plate corresponds
to the local mains supply
voltage.