Alto DIGAN2.30 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису Alto DIGAN2.30. Alto DIGAN2.30 15 сторінок. 2 x 30 band digital equalizer

Друкувати сторінку

3.2 The Rear Panel

TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
POWER
9 VAC
Rated Power Consumption 15W
(15)
11. DIGITAL OUTPUT SPDIF
This jack is used to output the digital signal to digital record device using a standard RCA cable.
12. USB SERIAL PORT
This serial port is used to connect the unit to PC with the supplied transmission line.
13. INPUT
These are XLR and 1/4" TRS balanced connectors, which are used to connect devices such as the channel
inserts of a mixing console.
14. OUTPUT
These are XLR and 1/4" TRS balanced connectors, which are used to connect sources such as the channel
inserts of a mixing console or power amplifier's input.
15. POWER INLET
This jack is used to connect the AC power supply with the supplied 9V AC adapter.
4. INSTALLATION & CONNECTION

4.1 Mains Connection

The 9VAC adapter that meets all the international safety regulations is supplied with your
Before power on the DIGAN2.30, please make sure all connections have been made correctly and the volume
controls of the amplifier or mixer are turned down.

4.2 Audio Connection

Both XLR and 1/4 " TRS connectors are available on your
DIGAN2.30 in several different ways without experiencing any noise or signal loss. You can use your DIGAN2.30
with single instruments using the mixer's main insert or on "in-line" between a mixing console's output and a power
amplifier.
- Wiring Configuration
Either the 1/4" TRS phone jack or XLR connector can be wired in balanced and unbalanced modes, which will
be determined by the actual application status, please wire your system as the following wiring examples:
For 1/4" Phone jack
TS Type Unbalanced
For XLR connector
XLR Type Unbalanced
OUTPUT
CH.B
CH.A
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
(14)
+
Tip
Sleeve
Pin2 (+)
Pin3 (-)
(Linked to Pin1 manually,
Pin1 ( )
INPUT
PUSH
CH.B
PUSH
CH.A
USB
SERIAL PORT
(13)
(12)
LTO DIGAN2.30. In this way you can interface your
+
-
Tip
Ring
Sleeve
TRS Type Balanced
Pin3 (-)
)
5
DIGITAL OUTPUT
SPDIF
(11)
Ring
TRS Type Unbalanced
Pin2 (+)
Pin1 ( )
XLR Type alanced
B
MODEL
SERIAL
LTO DIGAN2.30.
+
Tip
Sleeve