Alto MAXI-Q PC Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису Alto MAXI-Q PC. Alto MAXI-Q PC 15 сторінок. 30+30 band digital equalizer

Друкувати сторінку

Note: MAXIEDITOR software, which is used in the unit , accepts these four COM1-COM4 connectors of PC

only. So when you use USB port for connecting, please operate it as follows:

Please go to control section -> system -> DEVICE MANAGER -> advance -> COM connecting number, please

select one.

Then go to the tool bar of MAXIEDITOR -> Choose "OPTION -> USB to COM" and select the right COM.

Then it should be ok to link.

3.2 The Rear Panel

AC INPUT

95-240V 50/60Hz

FUSE:

95-120V T500mAL

210-240V T315mAL

Apparaten skall anslutas till

jordat uttag nar den ansluts

till ett natverk

Use only with a 250V fuse

A102

7. AC inlet and fuse holder

Use it to connect your MAXI-Q PC to the supplied AC cord. Please check the voltage in your country and what

voltage for your MAXI-Q PC is configured before attempting to connect the unit for the main AC. The fuse can

protect the AC supplies circuit of the equipment.

CAUTION:

If there is something wrong with the fuse or the fuse needs to replace, please refer to a qualified

technician. If the fuse continues to blow after replacing, discontinue using this unit before it is repaired.

8. RS485 OUT

This is the standard serial communication interface. It allows outgoing communication between a MAXI-Q PC

and other MAXI-Q PC units. The RS485 interface is very suitable for remote control over long distances (difficult

with RS232 standard ports) and daisy-chaining several MAXI-Q PC units.

9. RS485 IN

The function of the RS485 IN interface is opposite to RS485 OUT. It allows incoming communication between

a MAXI-Q PC and other MAXI-Q PC units. The RS485 interface is very suitable for remote control over long

distances (Difficult with RS232 standard ports) and for daisy-chaining several MAXI-Q PC units.

10. OUTPUTS

These (Outputs1~2) are balanced XLR-M connectors. The high quality, low noise, 24 bit converters can make

D/A conversion.

11. INPUTS

INPUT A and INPUT B are compatible with balanced XLR and JACK. They are audio connectors of the respe-

ctive sections. The high quality, low noise, 24 bit converters can make A/D conversion.

4. GETTING STARTED

The powerful versatile signal processor MAXI-Q PC is mainly designed for use with audio systems. Its configurations

of the input and output can be set only by recalling one of the presets included in the internal memory or PC Editor

software. So the user must be very clear about the main function of the unit in order to get a best operation of your

MAXI-Q PC. Before you start your operation, please read the following parts carefully:

4.1 Configuration of the system

At first, switch off the equipment, carry out the audio and power connection from the various components of your

sound system. Then, connect the main cord and only switch on the MAXI-Q. The display will show the data reg-

arding with the operating system release for a few seconds.

14W

RS485 OUT

RS485 IN

PUSH

1 . 0

PUSH

OUTPUTS

INPUT B

INPUT A