Clearance NFLS-x Series Посібник з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з монтажу для Ліхтар Clearance NFLS-x Series. Clearance NFLS-x Series 6 сторінок. Nfls-x series flexible led flexible light strip
Друкувати сторінкуConnection, Switch and Powering Options
The information and illustrations below offer recommendations for choosing a general design for your application.
Wall
Switched AC
12V DC
Switch
Outlet
Power Supply
Light strip On/Off is controlled by a
1
wall mounted switch.
120V AC
Outet
Wireless
LED Dimmer
Light strip On/Off/Brightness is controlled by
4
a wireless LED dimmer and signal receiver.
Wiring Considerations
Important factors to consider when designing your lighting system are:
•
The total lighting wattage your installation will require.
•
The length and size of wiring needed to connect LED light
strips to the power supply.
Use the chart below as a reference to minimize voltage drop.
Light Strip (Length in Ft.)
12
24
36
48
Layout Options
Power
Supply
Light strips are powered in a continuous "Straight"
run. Strips that are furthest from the power supply
1
are more likely to exhibit voltage drop.
Light strips are powered from a single looped "Loop-
back" connection, which also produces more consis-
3
tent results. Often used for room perimeter and cove
120V AC
Outet
2
12V DC
Power Supply
Wireless
LED Dimmer
Receiver
Recommended Maximum Wire Lengths - Power Supply to Light Strips
22 AWG Wire
Wire Length (Max Length in Ft.)
10
8
6
4
LED
Dimmer
12V DC
Power Supply
Light strip On/Off/Brightness is
controlled by an LED dimmer.
12V
Battery
Light strip is powered directly by a 12V
5
battery, for applications like boats, RV's, etc.
Voltage drop is the normal loss of voltage that
occurs as power flows along a wire connection
in low voltage systems, and increases as the
length of a wire connection is increased. Wire
length and thickness as well as total light watt-
age influence the amount of voltage drop.
Light Strip (Length in Ft.)
Light strips are powered from a spliced "Centerfeed"
connection. This type of layout tends to produce
2
more consistent brightness and color between strips.
In the "Array" option, light strip "legs" are individual-
ly powered. Total wattage should be determined so as
4
not to overload power supply.
2
120V AC
Wireless
Outet
Wireless
Wall Switch
Switch Receiver
12V DC
Power Supply
Light strip On/Off is controlled by a wire-
3
less wall switch and signal receiver.
LED
Dimmer
Fuse
12V
Protection
Switch
Voltage Drop
18 AWG Wire
Wire Length (Max Length in Ft.)
12
24
36
48
20
16
12
8