Clearance HTK2GW Посібник з експлуатації та інструкція - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з експлуатації та інструкція для Комерційне харчове обладнання Clearance HTK2GW. Clearance HTK2GW 2 сторінки. Upright glass door cooler

Друкувати сторінку

WELL VENTILATED PLACE

Please make more than 10cm space between

cooler and wall. If there are no space, cooling

capacity can drop down.

Never hang from the door or climb onto

the unit. The unit could tip over or fall and

cause material damage or injur y.

PROHIBITED

Grasp the handle when closing the door.

Holding at other positions could result in

pinched fingers and injur y.

DON'T PINCH

FINGERS

When disconnecting the power cord plug

from the wall outlet, hold at the plug main

body close to the outlet. Pulling the cord

could cause wire breakage, possible

resulting in overheating and fire.

Do not throw items onto the shelves and do

not place items totaling more than 30kg on

each shelf. The shelf could fall down,

possibly cause injur y.

PROHIBITED

PLACING ITEMS IN THE SHOWCSE

This showcase employs a forced circulation of cold air system. If circulation of cold air is obstructed, the

items will not be adequately refrigerated. Pay attention to the following points:

Do not let items obstruct the cold air inlet and suction outlet.

Place items so that they do not protrude from the shelves. The gap between the shelves and the door is

used for circulation of cold air.

Place items evenly on all shelves.

Please do not display goods on the bottom. Please put goods on the shelf.

CLEANING

To prevent any electrical shock hazards or injur y by rotating circulation fan, always disconnect the power

cord plug from the wall outlet before cleaning.

EXTERIOR AND COOLER COMPARTMENT

Wipe with a soft, dr y cloth. If ver y soiled, wipe with a cloth that has been moistened with a detergent. Then

wipe with a cloth that has been dipped in water.

WARNING: Do not splash water directly onto the cooler and do not wash with water. Short-circuit and

electrical shock could result.

Clean the cooler regularly to keep it clean at times.

Never use polishing powder, soap powder,

benzene,Oil or hot water as these will damage the

painting and Plastic components

To ensure the safety, perform the following checks after cleaning.

Is the power cord plug firmly inserted into a dedicated wall outlet? Confirm that the plug is not abnormally

hot.

Check the power cord for cracks and damage. Should the slightest irregularity be observed, contact the

dealer from whom you purchased this unit or our customer 's service.

WARNING

If installation in a damp location is

unavoidable, also install an electrical

leakage circuit breaker. If no electrical

DANGER OF

ELECTRICAL

leakage circuit breaker is installed,

SHOCK

electrical shock could result.

Disconnect the power cord plug from the

wall outlet before moving the unit and

make sure that the power cord is not

damaged during transport. A damaged

DISCONNECT

POWER CORD

PLUG FROM

power cord could result in electrical shock

WALL OUTLET

and/or fire

Do not push hand against or apply

excessive force to glass surfaces as the

glass could break and cause injur y.

DON'T TOUCH

Make sure that the unit does not tip over or

fall when it is moved. A falling unit could

cause serious injur y.

Be sure attach and secure shelves

correctly. An improperly attached shelf

could fall down and cause injur y.

WARNING

CHECKS

HOW TO USE

Remove shipping package, tape, etc and leave doors open ventilation for a while.

The unit is cleaned before shipment. However, clean the compartment interior once after deliver y

Please insert power supply plug into the wall outlet, single-phale to cat voltage.

Allow the unit to operate for about 1 hour to cool the compartment before placing items in the cooler

WAIT 5 MINUTES OR MORE BEFORE RE-STARTING

Restarting the unit immediately after it has been turned off may cause fuses to blow and activate the

circuit-breaker, the compressor may be overloaded, and/or other damage may occur

TEMPERATURE ADJUSTMENT

For showcase cooler,the interior temp.during fully loaded at factor y default setting of position at 4-5 will

℃.

be kept at 0-10

If the ambinet temp. is extremely high or the stuffing food inside is too much,that might

cause the interior temp. a little bit higher.So,it would be better turn the thermostat right so as to maintence

the right temp. On the opposite,if the ambinet temp. is ver y low or empty loaded,or in less food

storage,the interior temp. might be able to reach minus 0

up;Thus,it would better switch the thermostat back to left so as to relieve something.

Defrosting is performed automatically and drain water is collected in the drain tray.

Water is in the drain tray is evaporated automatically. In humidity, large amount of water in the drain tray,

so please throw away drain water once a day.

Please follow the below instruction, you could save energy.

To prevent cold air from escaping, open and close the door quickly and keep the door opened for as short

a time as possible.

Please install the unit in the place which is well-ventilated.

SHELF HEGITH ADJUSTMENT

The shelf height can be adjusted

Arrange the shelves in accordance with the dimensions of the items to be placed in the cooler.

In case the unit shows operating problems,

check the following prior to calling the authorized service company:

SYMPTOMS

POSSIBLE CAUSE

Faulty electrical contact

The unit is not

operating

Poor electrical power

Thermostat setting "0"

Unit is exposed to direct sun light

Not reaching

desired

temperature

Thermostat is not propertly adjusted

Clogger condenser

Blocked grills

Door not properly closed

Products poorly distributed

or excess product load

For Models with electronic

temperature controller,indicates E0 or E1

Abnormal noises

The unit is not properly level

Friction with other objects

Drain hose is outside of the drain pan

Water on the floor

WARRANTY & SERVICE

Warranty is valid for one year from the date of purchase.

The warranty covers defective parts and workmanship.The

following items are not covered under warranty:

1.Loss of products.

2.Damages caused by transportation.

3.Damages caused by modifications made by

unauthorized individuals.

4.Fluorescent lights,glass parts or plastic component parts.

5.Worn out plugs or defective electrical components.

6.Maintenance of the unit.

Warranty is valid showing the purchase receipt.

We offer a professional service network which offers the

necessar y technical support for your unit.

If the supply cord is damaged,it must be replaced by the

manufacturer,its service agent or similarly qualified

persons in order to avoid hazard.

Do not store explosive substances such as aerosol cans

with a flammable propellant in this appliance.

See contact information in the back of the Manual.

BEFORE USE

℃

,and in return to cause the evaporator ice

DRAIN TRAY

EFFICIENT USE

SOLUTION

Verify electrical connections

Check the power connection and electrical outlet

Change the thermostat setting to a higher number

Relocate the unit to a shaded area

Adjust the thermostat setting to a higher number

Review Maintenance instrutions listed in the manual

Clean the grills of any debris collected

Check the leveling of the unit and door seal

Redistribute the product load according

Start instrutions

Unplug the unit from the outlet.If the error

continues,contact an authorized service

technician

Level the unit following the Installation instructions

Move the unit and avoid contact with other objects

Lovate the hose in the drain pan