Akitio Taurus Super-S LCM Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Корпус Akitio Taurus Super-S LCM. Akitio Taurus Super-S LCM 17 сторінок. Dual-bay raid storage enclosure for two 3.5-inch serial ata hard drives

Друкувати сторінку

Taurus Super-S LCM

3.4.2 RAID Mode Setup

In order to set the RAID mode via LCD display, make sure the DIP switch position is set as follows:

1 up, 2 down. To lock the setting once it has been changed via LCD display or to set it by using the

DIP switch, please refer to the "Rear View" paragraph.

• [RAID 1] Confirm RAID 1 mirroring mode.

• [RAID 0->1] Change the mode from RAID 0 striping to RAID 1 mirroring.

• [RAID 0] Confirm RAID 0 striping mode.

• [RAID 1->0] Change the mode from RAID 1 mirroring to RAID 0 striping.

Press the [OK] button to enter the setup menu and press the [Select] button to cycle through the

different options.

• To exit the menu without changing any of the settings, press the [Select] button until you see

the Exit screen and then press the [OK] button.

• To change the setting, press the [Select] button to choose your preferred mode, press the [OK]

button to select it, press the [OK] button again to confirm the change and once more to

acknowledge that all data will be erased by this change. The device will restart automatically

and after start up, one more confirmation is required to set the new RAID mode.

Note

Changing the RAID mode requires you to re-format the drives. Make sure to backup all

existing data first!

[10]

LCD Display