3DUpFitters Artillery Sidewinder X1 Enclosure Kit Посібник з монтажу - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3DUpFitters Artillery Sidewinder X1 Enclosure Kit. 3DUpFitters Artillery Sidewinder X1 Enclosure Kit 13 сторінок.

Друкувати сторінку

There are also smaller connectors at the top and right side

when viewed from the front.

The front should look like the picture to the right. 

Locate the magnetic latch and use the wood screws to

attach them to the latch mounts. Hand tighten and make

sure they're secure, but do not over tighten or they may

strip. The latch can be later adjusted front-to-back to

make sure the door is ﬂush with the door frame. The

latch mount is attached via two M4 12mm cap heads

Attach the hinges to the door and door frame using M4 ﬂat head 12mm screws and

nuts. There will be some play in the hole size so that you can adjust the door to swing

freely.

Attach the door knob by ﬁrst inserting the square M4 nut into

the slot. Use a 16mm cap head screw to attach the door.