esera automation 11150 Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари esera automation 11150. esera automation 11150 7 сторінок. 1-wire multisensor pro for temperature and air humidity
Друкувати сторінку
Art. No. 11150
o
Automatic Positioning: The device logs on to any ECO Controller with Auto-E-Connect III with the new
request OWD number. This automatic login works up to the maximum possible OWD number of the
ECO controller
o
Sensorfinder Function: The ECO Controller can activate a status LED within the ESERA 1-Wire Pro
sensors. The status LED flashes or lights up permanently for a certain time. This makes the detection of
a device in a 1-Wire network much easier. A faster detection saves a lot of time and therefore money
when searching for a 1-Wire device.
o
Classes Assignment: ESERA 1-Wire devices are assigned to OWD classes with the same properties.
This assignment enables fully automatic visualization and data evaluation in control systems. A class list
is available from ESERA.
For further information about the ESERA Auto-E-Connect System please refer to the ESERA website and
the ESERA Config Tool 3.
Auto-E-Connect is registered as a German and European Patent by ESERA GmbH.
3
Technical data
Function
Temperature sensor
Measuring range
temperature
Accuracy temperature
Resolution
Humidity sensor
Measuring range humidity
Accuracy humidity
Data output
Interface
Connection
1-Wire interface
Operating voltage
Current consumption
Auto-E-Connect
4
Ambient conditions
Protection system
Protection class
Temperature, operation
Humidity
Dimensions (outside)
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH 2021
www.esera.de
Multisensor or temperature and rel.humidity
Monitoring of the operating voltage
high-precision digital temperature sensor with 12-bit measured value
resolution
-40°C to +85°C (Sensor element: -40°C to +85°C)
0,2° in the range 5 to 60°C (better than DS18B20 Sensor)
12 bit, 0.06°C/bit depending on selected resolution
capacitive digital humidity sensor with high accuracy
0-100% rel. humidity
2% in the range of 20-80% at 25°C
0-10V corresponds to 0-100% relative humidity, 0.1V = 1% rH
3 - wire connection (data, ground and 5V, parasitic operation not
supported)
screw terminal for cable solid 0.2 to 2.5qmm or
fine stranded 0,2 to 1,5qmm
for connection we recommend slotted screwdriver size 2,5x75
based on DS2438
5 V= (+10%/-20%)
approx. 2mA
level I,II, from 2022 level I-III
IP20
III
-25°C to 80°C, (limitation by carrier system, sensor -40°C to +125°C)
10 - 90% (non condensing)
71 x 71 x 32mm (LxWxH)
11150 V3.0 R1.0 Manual
Page 3 of 7