3DUpFitters FT-5 Enclosure Kit Посібник з монтажу - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3DUpFitters FT-5 Enclosure Kit. 3DUpFitters FT-5 Enclosure Kit 16 сторінок.

Finishing The Installation 

It may be tempting to try and make the installation air-tight, but that is not needed to

keep a constant temperature high enough for ﬁlaments such as ABS. The constant

heat from the bed heater will be more than enough to keep the inside of the enclosure

at the right temperature.

Filament Guide (Reverse Bowden)

This is designed to allow a side or top mount ﬁlament spool holder, guiding the ﬁlament from

outside of the enclosure to the extruder. There are two pieces, one to guide the ﬁlament into

the extruder, and another external piece to guide the ﬁlament into the PTFE tube.

First, remove the screws from the extruder carriage as shown below: