3DUpFitters MMU2S Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3DUpFitters MMU2S. 3DUpFitters MMU2S 11 сторінок.

much tolerance in the placement of

the oﬀ/on switch and power cable

plug, so you'll have to get it pretty

close. This will make it easier to turn

oﬀ and on and provide the best seal

so that heat won't escape.

7. Spool Holder

Instructions for assembling the spool holder are available online. You can simply sit the

spool holder on the top of the enclosure where the ﬁlament can ﬁt into the slit. Of

course, you are free to use whatever type of freestanding spool holder you wish; there

are hundreds of designs available on Thingiverse.

8. Thermometer

The optional thermometer will let you know

approximately what temperature it is inside

the enclosure. It attaches to the left side of

the door piece using the same hole as the

top-most corner connector as shown. It

comes with a longer screw to ﬁt through

everything.