ClearCube R1300 Посібник із швидкого старту

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Сервер ClearCube R1300. ClearCube R1300 2 сторінки. Bios version 3.27
Також для ClearCube R1300: Оновлення програмного забезпечення (2 сторінок)

Друкувати сторінку

R1300

Single-Processor Blade

R1300 LCD Panel

Reset

3 MSL Jumper JP6

USB Mass Storage

devices function

normally (default)

MSL Jumper

USB Mass Storage

devices do not

function

ClearCube Technology

Quick Start Guide

The R1300 single-processor blade offers dual integrated Ethernet con-

trollers and optional NVIDIA-based graphics to deliver a high-density,

high-performance computing solution to the ClearCube Architecture.

INSTALLATION

To install an R1300 blade, do the following:

1. Open the front bezel on the chassis by depressing the latches on

each side. The bezel swings forward and down.

2. Orient each blade right-side up (LCD panel on the bottom) and then

slowly insert the blade into the chassis by lining up the blade edges with

both the top and bottom guides in the chassis. There will be a slight

resistance to insertion when the back connector goes into the back-

plane socket.

3. After inserting all blades, raise the front bezel and snap it into place.

4. Depress the power button on the front of the blade to power it on.

When a blade is inserted into a chassis and powered on, it takes

approximately 30 seconds for the chassis and its RMM to detect the

blade and relay its information to Sentral.

Note: The very first time you insert the R1300 blade, the power does

not turn on automatically. You must depress the power button on the

front of the blade to power it on the first time. After the first power-on,

the blade uses its stored power setting to determine its unattended

power-on behavior.

R1300 FEATURES

Using the USB 2.0 capability of the R1300

The R1300 provides one USB 2.0 port on the rear apron of the R4300

when the blade has a 44-pin interposer installed. The 30-pin interposer

does not bring the USB 2.0 signals into the R4300 signal backplane.

Power

USB Port

CMOS Jumper JP1

Dual Ethernet Adapters on the R1300

Normal operation

The R1300 provides two Ethernet adapters. Connecting a network

(default)

cable to each of the blade's Ethernet jacks on the chassis will provide

two independent network connections and greater bandwidth. The pri-

CMOS Jumper

mary Ethernet controller provides gigabit Ethernet. The secondary

Clears CMOS

Ethernet provides 10/100 Ethernet. The dual Ethernet ports on the

password on

restart

R1300 are accessible as follows:

8834 Capital of Texas Hwy N

Jumpers on the R1300

The R1300 provides jumpers that control

CMOS password clearing and Mass Stor-

age Lockout (MSL). The default jumper set-

tings are:

•

JP1, pins 1 and 2 jumpered, CMOS

password is retained on restart.

•

JP6, pins 2 and 3 jumpered, MSL

control is enabled in software.

Austin, Texas 78759

voice 512 652 3500 www.clearcube.com