3DUpFitters Prusa i3 MK2 Посібник з монтажу - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3DUpFitters Prusa i3 MK2. 3DUpFitters Prusa i3 MK2 11 сторінок. Enclosure kit
Також для 3DUpFitters Prusa i3 MK2: Посібник з монтажу (18 сторінок)
Друкувати сторінку9. MMU2/MMU2S
The Prusa enclosure for the MMU2/MMU2S
is taller so there is room inside for the
MMU2/2S unit. It also contains 4 extra
grommeted exit holes to run the PTFE
tubes from the filament spools or detangler
box to the top-mounted multi-material
extruder.
The top grommet holes are for people who
are storing filament rolls in an above
cabinet or on the wall behind the printer.
The back grommet holes are for people who
will be placing the filament on the table directly behind the printer.
10. DIY Tool Holder
Our favorite customization is to add magnetic tool
holders to the side. One end can be attached via
the same hole as the corner connectors, but the
other end will require drilling a single hole.
You can find magnetic strips like this all over
Amazon or your local hardware store.
Copyright 2018 3DUPfitters
11