3DUpFitters Taz6 Enclosure Kit Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3DUpFitters Taz6 Enclosure Kit. 3DUpFitters Taz6 Enclosure Kit 15 сторінок.

The front should now look like the picture below.

You'll also want to make sure the front door swings smoothly. The easiest way is to lay

the enclosure on a towel on its side so the hinges are at the top. Loosen the screws

attaching the hinges to both the door and the door frame and use the magnetic latch

to hold the door in the middle of the hole. Now tighten the screws again, and the door

should swing freely.

If you still have trouble getting the door to swing freely, you can try reversing the

interior door if it wasn't attached in the same orientation as it was cut on the laser.

5. Assemble Back

The view to the right is of the back of the enclosure

when viewed from the back. The four corner

connectors are mirror images of the front on the

other side of the plastic in this view. The large hole

is either for an air ﬁlter (purchased separately) or can

be covered up by a plastic disc using short M4 10mm

screws. On the top and side are "mid-panel corner

connectors," which are simple L-shapes.