3DUpFitters Prusa i3 MK2 Посібник з монтажу - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з монтажу для Корпус 3DUpFitters Prusa i3 MK2. 3DUpFitters Prusa i3 MK2 18 сторінок. Enclosure kit
Також для 3DUpFitters Prusa i3 MK2: Посібник з монтажу (11 сторінок)
Друкувати сторінкуEverything You Wanted to Know About Screwing But
Were Afraid to Ask
Screw
Tool Needed
30-50mm
Hex Cap
3mm Hex Wrench
Head
12mm Hex
3mm Hex Wrench
Cap Head
16mm Hex
3mm Hex Wrench
Cap Head
#6 3/4" Wood
Philips Head
Screw
Screwdriver
Probably the most confusing thing about assembling this enclosure will be which fastener or
screw to use. Luckily it's pretty easy to figure out once you know the system. While the exact
screw to use will be detailed in each section of the manual, you probably won't need to refer to
it once you know the secrets.
The most common screw is the 12mm hex cap head screws. The 12mm screws are long
enough to attach things to the acrylic front, top, sides and back.
Each section will describe exactly which screw to use, to read carefully and use the specified
screw for the best results.
The actual length of the "long" screws to attach the fan and or filter will vary depending on the
depth of the particular shipment of fans we happen to get that month. They won't be hard to
spot since they'll be the longest thing in the bags.
Finally, and we can't stress this enough:
D O N 'T
D O N' T
Leave the screws a little loose until the end adjustment phase. During that process you'll be
hand-tightening until the screws are snug, but you can easily use so much force the plastic
pieces or the acrylic crack. Please don't be that guy.
Usage
Attach fan/filter, attach large
front latch mounts
Connectors, hinges
Knobs, small latch mounts on
some models
Attach magnetic latch to mount
O V E R T I G H T E N
U S E
A
P O W E R S C R E W D R I V E R
Copyright 2020 3DUPfitters LLC
Relative Size
T H E
S C R E W S
5