Alto-Shaam 1200-UPS Експлуатація та технічне обслуговування установки - Сторінка 10
Переглянути онлайн або завантажити pdf Експлуатація та технічне обслуговування установки для Комерційне харчове обладнання Alto-Shaam 1200-UPS. Alto-Shaam 1200-UPS 20 сторінок.
Друкувати сторінку
E L E C T R O N I C C A B I N E T C O N T R O L I D E N T I F I C A T I O N
on/oFF KEy
press the ON/OFF key once and the power
indicator light will illuminate. press and
hold the ON/OFF key until the LED display
turns off (at least three seconds) and power
indicator light goes out.
UP/down aRRow KEy
The up and DOWN arrow keys are used for a
variety of settings when selecting the holding
temperature. If an arrow key is pressed and
released the display will show the current set
temperature for two seconds. If an arrow key
is held (at least eight seconds), the value will
change at a rapid rate. If the arrow key is
pressed and released in rapid succession, the
set temperature will change by increments of
one degree.
EnaBLE / dISaBLE BEEPER
A beeper sounds when an error code is
displayed. To choose between beeper on
and beeper off mode, the control must be
off, then press and hold the DOWN arrow
key until either "ON" or "OFF" is shown
in the LED display. Release arrow key
when desired mode is displayed.
o P E R a t I n g I n S t R U C t I o n S
1
POwER ON INdICATOR LIghT
2
/
ON
Off kEy
3
hEAT INdICATOR
E L E C t R o n I C C o n t R o L S E t - U P
1200-UP MARInE • INSTALLATION/OPERATION/SERVICE MANUAL • 8.
4
LEd dISPLAy
5
LOCk INdICATOR
6
UP
ARROw kEyS
FaHREnHEIt/CELSIUS
With the control off, to choose between
°F / °C
Fahrenheit and Celsius, press and hold the
up arrow key until either °F or °C is shown
in LED display. Release key when desired
setting is displayed.
The control has a four-digit LED display.
When the display is on, it will show
current holding temperature, as well as
diagnostic information.
ContRoL LoCK
The warmer controls can be locked so that no
changes can be made to the set temperature.
To lock the display, press and hold the ON/
OFF key and the up Arrow key at the same
time. The lock LED will illuminate. When
the lock LED is illuminated, additional
programming will not be functional other than
the key sequence required to unlock the panel.
To unlock the display, press and hold the
ON/OFF key and the Down Arrow key at the
same time. The lock LED will extinguish. The
panel keys will resume normal function.
/
dOwN
1
2
3
4