ESI ESRTP4+ Інструкція з монтажу Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Терморегулятор ESI ESRTP4+. ESI ESRTP4+ 11 сторінок. Programmable room thermostat
Також для ESI ESRTP4+: Інструкція користувача (11 сторінок)

Друкувати сторінку
ESI ESRTP4+ Інструкція з монтажу Посібник з монтажу
6. Insert the 2 x AA batteries provided in the battery
compartment on the front of the thermostat,
underneath the fascia. The Programmable Room
Thermostat is now installed and will automatically
start to control the room temperature according to
the factory pre-set programme as shown in the User
Instructions. The display shows the correct time and
date which is automatically set together with the
actual room temperature.
10

3. Technical Settings

Setting TPI, Delayed or Optimum Start
3.1
1. Switch the slider to OFF. Press and keep holding the A
and H buttons together (under the fascia), then press
the Next
button to enter the technical settings.
Release all buttons.
2. Press the +/– buttons to choose between:-
OFF: The programme will run according to settings
DS (dL StAr DS): When ON, the programmer will run in
Delayed Start mode. The start of the next programme
may be delayed up to 45 minutes depending on the
room temperature
OS (OP StAr OS): When ON, the programmer will run
in Optimum Start mode
3. Press the Next
button and press the +/– buttons to
turn OP STOP (Optimum Stop) ON/OFF.
4. Press the Next
button to enter the TPI settings. Press
+/– to choose between:-
OFF: Working under normal swing value
3 Cycles: ON/OFF one cycle is 20 minutes. This is
recommended for oil boilers
6 Cycles: ON/OFF one cycle is 10 minutes. This is
recommended for gas boilers (default setting)
5. Press the Next
button to continue to the Sensitivity/
Swing and Calibration settings below.

Setting Sensitivity/Swing and Calibration

3.2
1. Switch the slider to OFF. Press and keep holding the A
and H buttons together (under the fascia), now press
11