ESI Cases billboard PSP-2 Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Спікери ESI Cases billboard PSP-2. ESI Cases billboard PSP-2 8 сторінок. 8” rechargeable party speaker
Друкувати сторінку
Powering up your speaker
1.Plug the micro USB plug into your speaker's micro USB charging port
2. Plug the USB side of your cable into your computer or laptop's USB charging
port, or into a standard USB charger (not included)
3. Make certain that your computer or laptop is powered on, or the USB charger
is plugged in to begin charging.
4. The Charging indicator LED light should illuminate RED when charging and
then turn off when the battery is fully charged. FOR MAXIMUM BATTERY
LIFE, IT IS IMPORTANT TO FULLY CHARGE YOUR BATTERY PRIOR TO USE.
5. Move the power switch to the ON position. The LED display should activate.
6.Adjust the volume control to the MIN position before connecting a device.
7.You're now ready to connect your device!
Connecting your wired microphone
1.Connect your wired microphone using a ¼" cable into the Mic Input.
2.Make sure your microphone is in the ON position and talk normally.
3.Adjust the Mic Volume to your desired volume level.
4.Adjust the master volume as needed.
Connecting your non-bluetooth device
1.Press the mode button until you see "AUX"in the LED sc reen.
2.You can connect most non-bluetooth devices using a 1/8" mini stereo cable.
Plug this into the 1 /8" mini aux input.
3.Play the music from your device, and adjust the volume on your device
to your desired level.
4.Adjust the master volume of your speaker to your desired level.
Connecting your USB Device
1.Plug your USB stick or USB device into the USB interface
2.The mode should switch automatically to "USB Mode"
3.Your speaker should automatically play the first MP3 song on your USB device.
4.Adjust the volume as needed.
5.Press the Next , Previous , Play/Pause buttons as needed.
4