ESi Ergo VICTORY 2VT-C48-30 Series Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Внутрішнє оздоблення приміщень ESi Ergo VICTORY 2VT-C48-30 Series. ESi Ergo VICTORY 2VT-C48-30 Series 8 сторінок. 2 leg electric table base
Друкувати сторінкуOPERATION
MOVING THE WORK SURFACE TO A SAVED POSITION
Use this function to move the work surface to one of the saved
positions.
• Press and hold the desired memory button, 1, 2 or 3. The work
surface will move to the saved position and then stop.
• Release the memory button. The work surface will move to
the saved position and then stop. The display shows the work
surface height.
CHANGING THE HEIGHT DISPLAY UNITS
This function allows you to change the display units from
centimeters to inches or the other way around.
• Press and hold memory buttons 1 and 2 and the UP s button.
• Release the three buttons after about five seconds. The display
will show S and a number — for example, S5.
• Press UP s until the display reads S5.
• Then press the Setting button S. If the display was set to
centimeters, it will now be set to inches; or vice-versa.
RESET THE CONTROL UNIT TO FACTORY SETTINGS
To reset the control unit to factory settings:
• Press and hold memory buttons 1 and 2 and the UP s button.
• Release the three buttons after about five seconds. The display
will show S and a number — for example, S5.
• Press UP s until the display reads S0.
• Then press the Setting button S. The control unit is now reset to
factory settings.
CAUTION: After resetting the control unit, the "zero setting"
procedure must once again be completed before operating the
table. See Step 12 on page 5.
VICTORY 2 LEG ELECTRIC TABLE BASE
If you release the memory button
before the saved position is reached,
table movement will stop.
If one or more motors are changed
in a system, the control unit must
be reset to factory settings and
the system must be "zero set" as
described earlier.
7