ClearOne MAX IP Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Конференц-телефон ClearOne MAX IP. ClearOne MAX IP 7 сторінок. Conferencing phone
Також для ClearOne MAX IP: Технічна специфікація (3 сторінок), Посібник користувача (6 сторінок), Технічний паспорт (2 сторінок), Посібник з інтероперабельності (4 сторінок), Брошура (2 сторінок), Посібник користувача (6 сторінок)
Друкувати сторінку
Using the Phone in a Three-Way Call
1.
Press the
HOLd key to place both lines on hold.
2.
Press the
ON/OFF key to hang up both lines.
>
Note: The Leds flash red when a call is on hold.
Press the HOLd key a second time to take both lines off hold and resume three-way conference call.
3.
If either of the other parties hangs up during the three-way call, the remaining party stays connected to the call.
To Make an Outbound Call While on Another Call
1.
Press the
HOLd key and then press the ON/OFF key. The first party is put on hold and you are connected to a
second line dial tone.
2.
dial the second party's phone number.
>
Note: stored numbers are not available for dialing a second party.
If you receive a busy signal or are routed to voicemail, then press the ON/OFF key to terminate the call and
return to the first party.
3.
Press the
HOLd key to toggle between the first and second parties or press the CONFErENCE key to join the two
parties in a three-way conference call.
>
Note: see TO MAKE AN OUTBOUNd THrEE-WAY CALL for more information.
To Accept an Inbound Call While on Another Call
1.
The phone rings (unless the ringer is muted) and the Leds flash green.
2.
Press the
HOLd key and then press the ON/OFF key. The first party is put on hold and you are connected to the
incoming call.
>
Note: If you want to disconnect the incoming call after answering it, press the ON/OFF key to hang up
the second call and then press the HOLd key to take the first party off of hold.
3.
Press the
HOLd key to toggle between the first and second parties or press the CONFErENCE key to join the two
parties in a three-way conference call.
>
Note: see TO MAKE AN OUTBOUNd THrEE-WAY CALL for more information.
toneS and aLertS
Tone/Alert
Confirmation
Reject
4
Technical support: 800.283.5936
Description
A tone will play upon successful programming entry.
A tone will play if you attempt to do any of the following:
• enter an invalid programming entry
• use a speed dial key that has not been programmed
(One-Touch Conferencing or service center)
• enter a 45th digit when predialing
• enter a 17th digit for user phone number
• enter a 31st digit for speed dial key (One-Touch
Conferencing or service center)
Figure 6 - MAX IP Tones and Alerts