Alto-Shaam 1000-MR2-1 Експлуатація та технічне обслуговування установки - Сторінка 6
Переглянути онлайн або завантажити pdf Експлуатація та технічне обслуговування установки для Холодильник Alto-Shaam 1000-MR2-1. Alto-Shaam 1000-MR2-1 19 сторінок.
Друкувати сторінкуw a r n I n g
Improper installation, alteration,
adjustment, service, cleaning, or
maintenance could result in property
damage, severe injury, or death.
READ and UNDERSTAND the
installation, operating and
maintenance instructions thoroughly
before installing, servicing, or
operating this equipment.
Position the refrigerated cart to allow sufficient air
ventilation through the condensing unit(s).
Avoid installing the chiller immediately adjacent
to fryers, charbroilers, or any other equipment
producing grease laden air; heat producing
equipment such as ovens and ranges; and steam
discharging equipment such as steamer ovens
and kettles. Do not locate the refrigerated cart in
direct sunlight.
Ins t al la t Io n
Prior to moving the refrigerated cart to the installation
site, check the dimensions of doors, passageways, and
ceiling heights in the areas through which the cabinet
must be moved. Also check the turning radius if the
cabinet must be moved around an existing structure.
The use of a fork lift or pallet lift truck is required for
moving and leveling most refrigerated cart models.
note: In certain instances, it may be necessary
to remove doors and door hardware to
negotiate tight spaces.
This unit must be placed on a level floor to ensure
the automatic door closing and correct draining
of condensate.
I n s t a l l a t I o n
MN-36246 (Rev. 1) 09/15 • MR2-1 Mobile Refrigerated Cart • 4
w a r n I n g
Appliance and accessories may be
heavy. To prevent serious injury,
ALWAYS use a sufficient number
of trained and experienced workers
when moving or leveling appliance
and handling accessories.
s I t e I n s t a l l a t I o n
cl ear ance reQ UIreMents
Full perimeter bumper accommodates all
clearance requirements.
Unit should not be tipped on its side.
If tipped, unit must stand in the
upright position for a mInImUm of 12
hours before operating. tipping will
cause damage to the unit and void the
warranty if not allowed to "rest"
If unit must be tipped, use extreme care.
Block casters to prevent unit from rolling
while lowering or lifting.
.