Altocraft 68125136 Посібник оператора - Сторінка 19

Переглянути онлайн або завантажити pdf Посібник оператора для Дриль. Altocraft 68125136. Altocraft 68125136 20 сторінок. 18v cordless drill / driver

Друкувати сторінку
OPERATION
Insert the switching adapter/plug into a 120V household current receptacle.
7.
The step of the battery pack has positive and negative terminal markings on
8.
it. Align these with the identical markings on the top of the charging stand and
insert pack into base. (Pack will not insert properly if reversed)
The green light is the charge indicator. When the charger is connected to AC
9.
household current, the green light is on.
The green light is the power indicator. When the battery is properly inserted into
10.
the charger and charging, the red light is on.
11.
Normal charging time is 3 to 5 hours. The charger will charge the battery at the
normal rate until charging is complete. The red light will turn off once charging is
complete. After the battery is fully charged according to the charging time provided
in the instructions, remove the battery pack from the charging stand immediately.
Battery temperature will cool to normal.
12.
When charging more than one battery pack, allow 15 minutes between
charges.
13.
After many charge/discharge cycles, your battery will lose its ability to hold
a charge. It should then be replaced. Dispose of batteries at an appropriate
waste disposal facility. Do not throw batteries away in common trash receptacles.
VARIABLE SPEED
1. You can vary the spindle rotation speed by modulating finger pressure on the
trigger (G in the functional description). Light finger pressure cause the drill speed
to be slow; heavier pressure will cause high drill speed.
2. Selecting high or low gear:
• Move the gear selector switch forward, exposing the 'HI' legend, to work in the
high-speed range.
• Move the gear selector switch backward, exposing the 'LO' legend, to work in
the low speed range.
• In the low gear (low-speed range), the drill turns with more torque, especially
good for operations that require more power than speed, such as driving
screws.
ROTATION DIRECTION
Your drill is equipped with a 3-position forward / reverse / neutral-lock switch (F in
the functional description) through the housing above the trigger.
1. When knob is pushed toward the left, rotation is forward (clockwise).
2. When pushed in from the left to the right side, rotation is reversed
(counter-clockwise).
3. When in center position, it is locked in neutral and the trigger is blocked. Do not
push the rotation direction knob until the chuck stops turning.
TORQUE REGULATOR
This is a 20-position ring (C in the functional description) situated between the
chuck and the drill body.
When arrow on the top of the housing points to 1 on the Torque indicator scale
1.
(D in the functional description), torque is at minimum before the clutch disengages
the chuck from the drive.
2.
When indicator is just past 19, output is at maximum before it is disengaged.
This is useful in driving screws into different types of material.
More torque will set a screw deeper into material, less torque will prevent it
3.
stripping. Larger screws require more torque to drive than small ones. A little
trial and error will show you which is the optimum setting for the situation.
4.
Release the trigger when the clicking sound indicates the chuck will not turn
further.
5.
For drilling, always use the drill setting, indicated by the pictogram of a drill bit.
At this setting, the drive does not disengage from the chuck.
19