Aimpoint Duty RDS Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Лупи Aimpoint Duty RDS. Aimpoint Duty RDS 12 сторінок.

4 TROUBLESHOOTING

The red dot does not appear or has disappeared

Make sure contact surfaces in the battery compartment

are clean and verify that a working battery (CR2032)

is installed correctly according to 2.1. If the sight is

malfunctioning, notify local dealer/armourer.

The sight is impossible to zero

If an adjustment screw (6) or (7) is at its limit, check the

alignment of mount and barrel. If point of impact is moving,

check if the sight is securely installed on the weapon and

check weapon rail (or carry handle) stability.

To avoid damage to the sight and for proper assembly of

the base (8) onto the sight, the original screws (10) must

be tightened by hand and with the Torx T10 tool (3).

a Place the sight upside down in your hand.

b Press the mount base (9) against the sight and verify

there is no gap.

c Apply thread locking fluid to the threads and install the

screws (10).

d Tighten the screws (10) in a crosswise pattern. Tighten

until resistance is encountered. Proceed with another

1/4 to 1/2 turn until fully tightened (1.35 Nm / 1.0 ft·lb).

CAUTION: Do not overtighten.