ClearSpan 104510 Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Намет ClearSpan 104510. ClearSpan 104510 15 сторінок. Frame 20' wide x 20' long

Друкувати сторінку

LAY OUT THE BUILDING SITE

After the site is prepared, identify the location of the shelter

corners to help square the frame after it is assembled.

Taking these steps before assembling the shelter saves

time and ensures that the structure is positioned as

desired. The following procedure is a suggested method.

Its use depends on the size of the shelter, shelter

application, the footings, and the method used to anchor

the shelter.

SQUARE THE SITE

Identify a corner where a building rafter will be

positioned, drive in a stake, and string a line the exact

width of the building and stake in place. (Width of the

rafter is measured from center-to-center of the rafter

legs.)

String a line at least as long as the building from the

first stake at 90°.

NOTE: A transit can be used to ensure an accurate 90°

angle, or the 3-4-5 rule can be used. Refer to diagram.

Using multiples of 3-4-5 such as 6-8-10 or 12-16-20

helps to maintain an accurate 90° angle.

After squaring the position of the building and placing

a stake at all corners, string a line between the stakes

to mark the base of the building.

Next, paint or mark a line on the ground using the

strings between the stakes as guides.

Revision date: 07.01.08

CLEARSPAN

NOTE: Setting customer-supplied baseboards on the

site in the correct positions is another way to prepare

for the frame assembly.

Rod or Ground

Stake

Actual rafter is not shown.

The baseboards can be "pinned" in place using rods

driven into the site through evenly-spaced holes drilled

in the baseboard. This prevents the baseboards from

shifting during assembly.

Building width is measured on-center.

After marking the outline of the building, continue with

the assembly instructions.

JUBILEE TENTS

™

NOTE: If a baseboard

is used, drill holes

through the board at

evenly-spaced intervals

along the length of

the board. Drive a rod

through each hole and

into the site to prevent

the boards from shifting

and to maintain the

on-center width of the

building.