Bambi PT Series Посібник оператора Посібник оператора - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник оператора Посібник оператора для Діапазони Bambi PT Series. Bambi PT Series 8 сторінок.
Також для Bambi PT Series: Посібник оператора Посібник оператора (12 сторінок), Посібник оператора Посібник оператора (12 сторінок)

Adjusting Outlet Pressure

Use the pressure regulator to adjust the outlet pressure.

To increase line pressure, rotate the knob in a clockwise

direction; to decrease turn anti clockwise. It is possible to

lock the setting by pushing the knob down until it "clicks".

Filter/Regulator [PT90]

There are two pressure gauges on each model.

The larger gauge indicates the air receiver pressure, the smaller gauge indicates the

air outlet pressure.

Routine Maintenance

Refer to preventative maintenance section for frequency. [Page 5]

Draining the Air Receiver

Drain water condensate from air receiver at a pressure of no more than 2 Bar. Slowly

open the drain tap provided to allow water to flow out. Fully close drain tap when all

water condensate has drained off.

Draining the Filter/Regulator Unit (PT90)

Drain water condensate from the filter regulator at a pressure of no more than 2 Bar.

Push the drain pin at the bottom of the filter regulator to allow water to flow out.

Note !

Water Condensate must be handled in accordance with national environmental rules

Check Pressure Relief Valve

Ensure the air receiver is not pressurised.

Unscrew the knurled end of the pressure relief valve until an

audible click is heard. Retighten without using excessive force.

Pressure Relief Valve