ClearSpan SunBurst Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Намет ClearSpan SunBurst. ClearSpan SunBurst 13 сторінок. Dome tents

Друкувати сторінку

FRAME ASSEMBLY (CONTINUED)

7. Verify that the mounting bolts are tight and install the

tent legs (#131P090D). Use additional help if needed.

8. Secure the legs using the 1/4" x 2" bolts and nuts.

9. After securing each pipe splice and verifying that all

mounting bolts are tight, move the frame to the desired

location if needed.

10. Adjust the leg width to 10' on-center. Measure from

the center of one leg to center of other leg. Adjust if

needed.

10'

NOTE: To help prevent the leg pipes from sinking into

the ground, place wood blocks or other similar supports

under each leg.

11. Continue by anchoring the tent frame.

ANCHOR THE SHELTER

At this point, anchor the shelter. Consult the MUST READ

document for anchoring information and suggestions.

Please call customer service at 1-800-245-9881 for

additional anchoring information.

OPTIONAL INSTALLATION - SIDE PANELS

If the shelter includes the optional side panels (additional

purchase required), these panels are attached to the frame

before the main cover is installed. If the shelter does not

include the optional panels, continue with the main cover

installation steps.

NOTE: Like the main cover, the optional side panels are

attached to the frame using the snugger balls (CC4595)

in the manner illustrated. Do not install panels without first

anchoring the assembled frame.

Continue with these steps to attach the side panels:

1. Unpack panels and unfold completely.

2. After anchoring the frame, lift the panel into position,

10'

3. Install all side panels and continue with the main cover.

Visit www.ClearSpan.com for additional products and customer assistance.

CLEARSPAN

CAUTION: The anchor assembly is an integral part

of the shelter construction. Improper anchoring may

cause shelter instability and failure of the structure

to perform as designed. Failing to anchor the shelter

properly will void the manufacturer's warranty and may

cause serious injury and damage.

place the snugger balls through the grommet holes,

and loop around the lower end rafter legs.

NOTE: Secure the top edge of the panel if it is

equipped with grommets. Some panels may not include

grommets along the upper or lower edges.

DOME TENTS

™

Optional

Side Panel