ClearSpan Premium Solar Star 104918 Інструкція з монтажу Посібник з монтажу - Сторінка 15
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Комплект для теплиці ClearSpan Premium Solar Star 104918. ClearSpan Premium Solar Star 104918 17 сторінок. Home-attached greenhouse
Друкувати сторінкуTek screws and washers are reinstalled through the
flashing to secure it to the greenhouse.
Complete these steps to install the flashing.
1. To install the flashing, begin at one of the lower front
corners and work to the other lower corner of the
same end.
Photo shows installing the first section of flashing.
Greenhouse may be a similar model.
2. Cut the flashing edge to allow it to bend at the
correct angle as it is attached.
ATTENTION: To prevent interference with the hinged
small side panels and solar openers, additional
"trimming" of the flashing is necessary along the edges
of the hinged panels.
3. After attaching the first section, install the next
section and overlap the first section by a few inches.
Visit www.ClearSpan.com for additional products and customer assistance.
Flashing will over-
lap the angled end
panels as shown.
REMEMBER: Flashing is installed under the
polycarbonate of the roof panels and it overlaps the
polycarbonate of the end panels.
4. Continue to install the flashing until one end is
complete.
5. Repeat the steps until all flashing is installed.
6. Continue with the final check of the greenhouse.
NOTE: The flashing that remains can be used when the
greenhouse is attached to the permanent structure.
FINAL CHECK OF ASSEMBLED GREENHOUSE
1. After all flashing is installed, inspect the assembled
greenhouse and verify that all brackets are in place
and secure.
2. Inspect all corner brackets to verify that all panel are
secured to these brackets.
3. Verify that all pass-through connectors are secured
to the metal base frame and to the panels.
4. Remove any sharp corners or edges that are
present to prevent injury.
Door (and
Non-Door)
End Panel
14 of 16