ClearSpan R035B00011A Посібник - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник для Комплект для теплиці ClearSpan R035B00011A. ClearSpan R035B00011A 15 сторінок. Greenhouse door kits
Друкувати сторінкуDoubLe TWIN-WALL DooR ASSeMbLY (continued)
10.
Place one (1) main handle of assembly through hole
in door and twist main handle and front plate into
place as shown in the drawing below.
11.
Mark the plate mounting hole locations on the panel
and drill a 5/16" hole through the panel and door
frame. Support frame with a block of wood if needed.
12.
Slide back mounting plate into position, square it with
the mounting holes and front plate and secure using
two (2) ¼" x 3" bolts and lock nuts. Verify that latch
turns freely. Mount one (1) door latch guide (slotted
plate) using the remaining ¼" x 3" bolts. Position so
latch handle is level. See below.
Latching
Door Latch
Plate
Guide
13.
After assembling the doors, evenly space the three
(3) hinges along the door frame of each door and
attach the hinges to each assembled door using Tek
screws.
8
Twin-Wall Double Swinging Doors
Horizontal
Position
14.
With assistance, set the assembled doors in the end
wall door frame and secure hinges to the door jamb
using one Tek screw per hinge at this time.
Locations of door hinges may vary.
NoTe: Verify that there is sufficient clearance along
all door edges to allow the doors to swing freely in
the opening. If end panels are installed, either attach
to the outside of the end panels as shown above or
loosen the panels, secure the hinges directly to the
door jamb, and reinstall panel fasteners.
15.
Test the door operation, adjust hinges as needed,
and install the remaining Tek screws.
16.
Attach the 6" chain bolt to the inside, upper corner of
the door without the handle (see X in drawing below).
Mount the latching plate to the outside of the same
door (see drawing in step 12). The screws supplied
with the latch are not used for metal jambs.
X
Door
without
handle.
Inside
View
outside
View
Revision date: 05.28.10