ClearSpan 2040SS Посібник - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник для Притулки ClearSpan 2040SS. ClearSpan 2040SS 18 сторінок. Add-a-bay shade system
Друкувати сторінкуLAY OUT THE BUILDING SITE
After the site is prepared, identify the location of the shelter
corners to help square the frame after it is assembled.
Taking these steps before assembling the shelter saves
time and ensures that the structure is positioned as
desired. The following procedure is a suggested method.
Its use depends on the size of the shelter, shelter
application, the footings, and the method used to anchor
the shelter.
The procedure may not apply to your shelter.
SQUARE THE SITE
1. Identify a corner where a building rafter will be
positioned, drive in a stake, and string a line the exact
width of the building and stake in place.
2. String a line at least as long as the building from the
first stake at 90°.
NOTE: A transit can be used to ensure an accurate 90°
angle, or the 3-4-5 rule can be used. Refer to diagram.
Using multiples of 3-4-5 such as 6-8-10 or 12-16-20
helps to maintain an accurate 90° angle.
3. After squaring the position of the building and placing
a stake at all corners, string a line between the stakes
to mark the base of the building.
4. Continue by reading the anchoring information that
follows.
Revision date: 10.04.07
ANCHOR THE FRAME
Turnbuckles and ground anchors can be used to anchor
this type of shelter. Ground posts and mounting feet can
also be used with the above items. Consult a reliable
construction professional if you need assistance when
anchoring the assembled frame.
CONSULT THE MUST READ DOCUMENT FOR
ANCHORING INSTRUCTIONS. FRAME MUST BE
ANCHORED TO THE SITE.
Contact Customer Service at 1-800-245-9881 to purchase
additional parts to anchor the shelter.
ASSEMBLING THE SUNBLOCKER™ SHADE FRAME
COMPONENTS
NOTE: Assistance may be required to assemble the frame.
PURLIN ASSEMBLY
Pre-assemble the 20' purlin assemblies using two (2)
10' plain pipes and one (1) coupler. See chart below for
number of required assemblies per shelter.
Gather the parts:
•
•
•
Shelter #
1. Connect a pair of 10' pipes using the straight coupler.
2. Secure the pipe in the coupler using 3/8'' x 1'' cap
Visit www.ClearSpan.com for additional products and customer assistance.
CLEARSPAN
WARNING: Securing the legs to concrete blocks or
wood boards set on the site is not a substitute for
properly anchoring the shelter. You must anchor the
shelter to the site.
FAILING TO PROPERLY ANCHOR THE SHELTER
WILL RESULT IN DAMAGE TO THE SHELTER AND
MAY CAUSE PERSONAL INJURY.
Plain pipe (#2375P120)
Straight coupler (#103837)
Cap screw 3/8'' x 1'' (#FAG355B)
Qty.
2020SS
3
2040SS
6
Pipe
2060SS
9
screws through the threaded holes of the coupler.
NOTE: You can assemble all the 20' purlin assemblies
required for your shelter at this time, or assemble them
as you go.
SUNBLOCKER SYSTEM
™
Coupler
Pipe
Cap Screws
7