Altrad PROMIX 1800 Оригінальні інструкції, інструкції з техніки безпеки, запасні частини - Сторінка 8
Переглянути онлайн або завантажити pdf Оригінальні інструкції, інструкції з техніки безпеки, запасні частини для Електроінструмент Altrad PROMIX 1800. Altrad PROMIX 1800 12 сторінок. Handheld agitator
Друкувати сторінку
Do not operate the machine when you are ill, feeling tired, or when under the influence of alcohol or drugs.
Ensure that the mixing container is placed on a fla! and firm area.
Do not place body parts or any other items into the mixing container du ring the mixing process.
@
Vibration.
Sorne vibration from the mixing operation is transmitted through the handle ta the operator's hands.
PPE (Persona! Protective Equipment).
Suitable PPE must be worn when using this equipment i.e. Safety Goggles, Gloves, Ear Defenders, and Steel Toe capped footwear.
Wear clothing suitable for the work you are doing. Tie back long hair and remove any jewellery which may catch in the equipment's
moving parts.
Electric Machines.
Electricity can kill! Always ensure that the machine is disconnected tram the power supply before carrying out any maintenance/repairs.
Never use the machine in wet conditions.
@
Pre start-up inspection.
The following Pre-start-up inspection must be performed before the start of each work session or after every four heurs of use, which
ever is first. Please refer to the service section for detailed guidance. If any fault is discovered, the Promix must no! be used until the
fault is rectified.
1. Thoroughly inspect the Promix for signs of damage. Check components are present and secure. Pay special attention ta the
Mixing Paddle, and ensure it is correctly attached to the handle.
2. Check electricity cables for signs of exposed wires. Fix any exposed areas before operating.
@
m
WARNING
Before you operate or carry out any maintenance on this machine VOU MUST READ and STUDY
llWJ ..........
=== th1s manual.
Always operate the machine with bath hands on the handle.
Press and hold the trigger (2) ta commence the mixing process.
Once the trigger (2) is in the 'ON' position, push the trigger Iock button (3). This will hold the trigger (2) in the 'ON' position without the
use of your hand.
To stop the machine, push and release the trigger(2).
Machines with 2-speed gearboxes have 2 speeds available. The first gear is the slow speed, and the second gear is the fast speed.
To change !rom one gear to the other, turn the gear change switch (1) through 180
which allows you ta vary the speed of the machine when using either of the 2 gears.
Always reduce the speed when placing the mixing paddle into the mixing material, and also when removing it. Once the mixing paddle
(6) is completely clear of the mixing material, increase the speed again to ensure that the motor is adequately cooled.
During the mixing process, slowly move the machine around the mixing container. This should be continued until all of the mixing ma
terial has been mixed.
Once the mixing process has been completed, clean the mixing paddle (6) to stop the build up of dirt and residue.
Note: The numbers shown in brackets refer ta the pictures shown in the Machine Description section of the booklet.
@
/X"\
Safe Disposai.
l{�U
Instructions for the protection of the environment.
The machine contains valuable materials. Take the discarded apparatus and
'é:J
accessories ta the relevant recycling facilities.
Health And Safety
Pre-start Checks
Operating Instructions
Environ ment
8
. There is also a Variable Speed Dial (7) available
°
-