Edgewater Networks EdgeProtect 7300 Посібник з експлуатації обладнання - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з експлуатації обладнання для Мережеве обладнання Edgewater Networks EdgeProtect 7300. Edgewater Networks EdgeProtect 7300 16 сторінок. Enterprise session border controller 7000 series
Також для Edgewater Networks EdgeProtect 7300: Посібник з встановлення обладнання (18 сторінок)
Друкувати сторінку7300 Hardware Guide
Physical Installation
The 7300 is designed for desktop or rack mount installation. Observe the following guidelines when installing the system:
Always verify that the AC cord is disconnected from a power source prior to installation.
Ensure that the installation site has adequate air circulation and meets the minimum operating conditions for the system as
specified in the Specifications and Certifications section of this document.
Desktop or rack shelf Installation
Remove the 7300 and accessories from the shipping container.
Place the 7300 on a flat, dry surface such as a desktop, shelf or tray.
Rack- Mount Installation
Remove the rack mount kit supplied in the shipping container and install the kit on the 7300
Mount the completed assembly into your 19" equipment rack.
Connecting the Power and Cables
The 7300 comes with an AC power cord for connecting the unit to the AC outlet.
Warning:
Always connect the AC power cord to an AC outlet suitable for the power supply per the Power specifications listed in this
document in order to reduce the risk of damage to the 7300 power supply.
Connect one end of the AC power cord to the 7300 input power socket and the other one to the AC outlet. Connecting the AC
power cord to the input power socket of the 7300 may require a little force to get the plug properly positioned
Caution:
Secure the AC power cord using a fastener or tie wrap to a cable management system to unsure the 7300 does not hang from
the AC outlet.
If connecting to an Internet router, Internet DMZ switch, cable modem or DSL modem, connect the Ethernet cable to the Ethernet
WAN Port 2 on 7300 and the other end to the WAN device.
6