ClearWater clearspa Інструкція з монтажу Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Ванни ClearWater clearspa. ClearWater clearspa 8 сторінок.

10. Once the air pipe has all been connected you can wire the touch pad into the

blower. Certain baths have room for the touch pad to be fitted on the bath rim.

If the touch pad is separate to the bath a place must be found else where to

fit/attach the touch pad.

11. The touch pad is wired into the back of the blower. Unscrew the two screws

at the back of the blower to unveil the connecting block as shown below.

12. The wires of the blower go into the connector block on the left hand side. If your

touch pad is fitted with a white jack you must cut it off. You are left with eight wires.

To wire the touch pad into the blower you only need five of the eight wires. The wires

that you need are grey, black, blue, yellow and red. The other remaining three wires

can be either cut down to the core or taped up.

The order the wires connect in are as follows. 1. - grey, 2. – black, 3. – blue, 4. –

yellow, 5. – N/A and 6. – red. This is shown in the picture below

To extend the touch pad wire, you will need to purchase a 5 core alarm wire. The

extended connections must be made by a qualified person.

Place the cover back on the blower.

Clearwater Clearspa Instructions 09/06