ClearWater Lights Erica Посібник з монтажу - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник з монтажу для Аксесуари для мотоциклів ClearWater Lights Erica. ClearWater Lights Erica 16 сторінок. Kawasaki concours 1400 led light kit dimmable patent pending
Також для ClearWater Lights Erica: Посібник з монтажу (12 сторінок), Посібник з монтажу (8 сторінок)
Друкувати сторінку
Step 4: Wiring
Electrical:
• Run the Red and Black power wires directly to the battery. The fuse will
protect the system in the event of a short.
• Mount the power relay box in a safe location (see photo below for one
recommended location). Secure with a zip tie. It is a good idea to face
the relay box with the wires coming out of the bottom. This helps keep
everything dry.
Under beak relay box location.
• Route the two Black connectors for the lights to a convenient location
where they will not interfere with steering or any other moving parts.
• Install the switch in a convenient location. Refer to the sticker on the
switch for proper placement.
• Switch - Crimp spade lugs to red, yellow, and black wires from relay box.
Attach to corresponding tabs on switch. (See wiring diagram)
• Using Posi-tap, attach red (turn on wire) to a switched 12v wire. Be sure
not to use a Low beam headlight wire on H4 headlight bikes or else the
lights will shut off when the high beam is activated.
• Install connectors as shown in the wiring diagram on page 7.
High Beam Feature:
Locate your bike's High Beam headlight hot (+) lead. This will
make your lights go to full power when you turn on your high beam. Use
a Posi-tap to connect one of the white wires from the relay box to this
wire. It does not matter which white wire you use; both trigger the same
way. If you do not want to use this feature, simply tuck the white wire
away in a neat fashion.
Horn Feature:
Locate the Horn's hot (+) lead. This will make your lights flash
to full when you sound your horn. Use a Posi-tap to connect one of the
white wires from the relay box to this wire. It does not matter which white
wire you use; both trigger the same way. If you do not want to use this
feature, simply tuck the white wire away in a neat fashion.
Page 14
Page 13