Acoustics QI0120 Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу для Стереосистема Acoustics QI0120. Acoustics QI0120 11 сторінок.

First fix for line output

The analogue 3.5mm stereo line output can be used to connect an external amplifier or sub-woofer.

Note that analogue audio signals are prone to picking up interference and this line output should be

limited to 10m.

E120 can be fitted into a bathroom environment, which is different to most other rooms in the home. The

nature of this wet environment is recognised by the respective standards authorities who test products

in terms of their suitability to be installed in such areas.

E120 compiles with IP54 (Ingress protection).

E120 system is defined as an 'Extra Low Voltage Installation', but the wiring needs to be installed in

accordance with 'Part P' of the Design and Installation of Electrical Installations. If in doubt, you are

advised to seek assistance from a qualified electrician.

Please refer to the diagram below, E120 should be installed in either zone 2 (light blue) or zone 3 (white).

Reaching IP54:

E120 is supplied with two rubber gaskets of different thicknesses which should be stuck to the wall side

of the metal frame prior to screwing the frame to the back box. This will create a seal between the frame

and the wall and ensure better water protection. If the wall is flat then the thinner 1mm gasket can be

used, for uneven walls (such as between tile joins) then the thicker 2.5mm gasket can be used.