ClearWater Lights Glenda Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з монтажу для Освітлювальне обладнання ClearWater Lights Glenda. ClearWater Lights Glenda 12 сторінок. Led light kit for bmw k1600gt
Також для ClearWater Lights Glenda: Посібник з монтажу (12 сторінок), Посібник з монтажу (12 сторінок), Посібник з монтажу (12 сторінок), Посібник з монтажу (16 сторінок)

Step 5: Alignment / Drip Loop Instructions

Aligning The Lights:

Adjustment is up to the user depending on his needs. Ask an

assistant to help you with this procedure. Make sure the bike is on level

ground and have an assistant sit on the bike. With a right angle board

or object, position the board on the floor and slide it up to the light. The

goal is to adjust the lights so that the light is level with the ground.

Passengers and luggage may alter the alignment of the light, so

further adjustments may be needed. You may find that a slight downward

angle (5 degrees) is helpful. Often times it is helpful to angle the right

side light toward the right side of the road. This helps with identifying

road terrain and potential critters.

Using a Drip Loop

Though our lights are sealed for ultimate all weather use,

sometimes water sneaks by. To make sure this doesn't happen, we

highly suggest using a drip loop. When installing the wiring to your lights,

use a drip loop as shown below. This will keep water from dripping

directly into the light and instead fall off before it can reach the back of

the body.

To do this just leave a bit of extra wiring and let it hang below the

light. You could make a complete loop if you like, but just make sure the

wire hangs below the light as shown below.

Page 10

No Drip Loop

Page 9

With Drip Loop