ArtFox Beam 15R extreme Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Світильник ArtFox Beam 15R extreme. ArtFox Beam 15R extreme 9 сторінок.

supply. It must cool at least 15 minutes to work again after power supply

cut off, or it will induce high pressure discharge, short circuit, and even

burn out parts of computer control panel.

3. Power supply

Using appropriative plug connect computer light and power main lead.

Pay attention to consistent of voltage, frequency and supply source of

backboard of computer light. Suggest each computer light to use a

separate power supply, so each light can be turn on and turn off at will.

Important matters:

Each computer light should be earthed and whole electro assembling

must accord with standard demand.

The power consumption of computer light is 680VA.

Monitoring restoration system:

After computer light switch on power, circuitry will be install. This

function makes lamp cobra moving to a limiting position, and it will turn

interior color and superimposed wheel of pattern. Thus the control system

of microprocessor can login all place of electrical machines which

controlled by it. It will bring electric noise in computer interior, when

modulator tube damage or burnout. Maybe it will disturb normal

operation of MPU. Computer light has an electronic monitoring system

that can watch operation of MPU, and ensure that will start up

reinstallation function when it is disturbed. After it finish, computer light

can accept new control instruction and operate without a hitch.

4. Connection of control communication line

Connection of controller and computer light or connection between

each computer light should use two-core shielded cable, and diameter of

each core should be o.5MM at least. When it joined in or come out, it

should be used cylindrical three-legged XLR plug and outlet which

L=Brown

E=Yellow/Green

N=Blue