ClearWave CW-125 Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Диспенсер для води ClearWave CW-125. ClearWave CW-125 10 сторінок. Water conditioner
Друкувати сторінкуFigure 2
Properly wrapping the antennae
The antennae wrap around the water pipe on each end of the ClearWave.
(See Figure 2) A minimum of seven fully wrapped coils of the antenna
wire, with each coil wrapped tightly against the pipe and pressed snugly
against each other, is required for best results. The operation of the
ClearWave and the antenna installation is not based on direction of water
flow, but one antenna MUST be wrapped in a clockwise direction and the
other wrapped in a counter-clockwise direction.
Wrap the right antenna clockwise (over the top of the pipe first), keeping
the antenna wire tight against the pipe and the preceding coil. Secure
the end of the right antenna wire to the water pipe with a wire tie. (See
Figure 3) Wrap the left antenna counter-clockwise (under the bottom of
the pipe first), keeping the antenna wire tight against the pipe and the
preceding coil. Secure the end of the left antenna wire to the water pipe
with a wire tie.
Figure 3
Connecting to power supply
Insert the power supply terminals onto the power supply screw terminals and fasten securely. Plug the power
supply into a standard electrical wall outlet. (See Figure 2) When energized, the ClearWave modulation
indicator lights start flashing sequentially indicating that the ClearWave is functioning properly.
page 5