ARTFOX Lighting IP WASH 44 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Ді-джейське обладнання ARTFOX Lighting IP WASH 44. ARTFOX Lighting IP WASH 44 8 сторінок. 44 rgbw 4in1 led wash light

Друкувати сторінку

4. Preparing for installation

Unpack the fixture and inspect it to ensure that it has not been damaged during

transport.

The fixture is shipped with two quarter-turn brackets, that can be used to

mount the fixture at elevation.

The fixture is IP55-rated, and is designed for use in wet locations. This means

that it is protected from:



Dust, to the degree that dust cannot enter the fixture in sufficient

quantities as to interfere with its operation.



Lower pressure jets of water from any direction.

When selecting a location for the fixture, ensure that:



It is situated away from public thoroughfares and protected from contact

with people.



It is not immersed in water or exposed to high-pressure water jets.



It has adequate ventilation.

5. Installation

The fixture may be installed in any orientation, but if installed horizontally with

a downward beam-angle, water can potentially pool in the fan wells. Under

normal operation the moisture will evaporate. However, in locations with high

rainfall, you may wish to fabricate a rain shield above the fixture, or modify the

position and orientation of the fixture to minimize pooling.

For permanent installation on the ground, remove the rubber feet from the floor

stand/ base. Fasten securely through the resulting holes with four corrosion-

resistant mechanical fasteners suitable for the location.

Setting the DMX address

The DMX address can be seen on the main screen. To change the address

setting, press the up arrow to increase the address, or the down arrow to

decrease the setting. When the desired address is displayed, press Enter to

save the setting.

Note that channel spacing is determined by the DMX mode.

See the "DMX protocols" on page 13 for specific DMX control values.

Setting the DMX mode

Using the "DMX mode" menu available from the control panel, specify the DMX

mode that provides the fixture controls that you require, confirm chosen mode

by pressing 'Enter'.

10. Cleaning

To maintain optimal performance, regular cleaning is essential. Cleaning

schedules will vary depending on the operating environment, and the

installation should therefore be checked at frequent intervals within the first

few weeks of operation to see whether cleaning is necessary. This procedure

will allow you to assess cleaning requirements in your par- ticular situation.

Clean the fixture using a soft cloth dampened with a solution of water and a

mild detergent. Do not use products that contain solvents, abrasives or caustic

agents for cleaning, as they can cause damage to both hardware, cables and

connectors.