Edic ENDEAVOR Посібник користувача/оператора - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник користувача/оператора для Ультразвуковий очищувач ювелірних виробів Edic ENDEAVOR. Edic ENDEAVOR 17 сторінок. Multi-purpose extractor
Також для Edic ENDEAVOR: Короткі посібники (15 сторінок)
Друкувати сторінкуUSING A 9000AC SPRAYER
(NOT INCLUDED):
Use the spray collar to select between low pressure
chemical application or high pressure rinse. Pop "OUT"
for low pressure and "IN" for high pressure.
High Pressure
Low Pressure
You may also adjust the angle of spray from a concen-
trated stream to a wider pattern by rotating the spray
collar clockwise or counter-clockwise.
NOTE: CHEMICAL WILL NOT DRAW IN HIGH
PRESSURE RINSE MODE.
OPERATING INSTRUCTIONS FOR
TOUCHLESS RESTROOM CLEANING
USING 991RS:
Use the following instructions as a basic guideline to
clean hard surfaces using the ENDEAVOR and the
991RS system.
1. Select the appropriate tip and install on the intake
cap.
2. Place bottles into the bottle holders.
3. Select chemical using chemical selector valve.
4. Take the feed tube attached to the intake cap and
place it inside the bottle. Thread the intake cap onto
the bottle.
1. Plug in power cords as per instructions on page 8.
2. Make sure you are on 2 circuits.
3. Connect your solution hose to machine and 9000AC
spray gun.
4. Fill the machine with water. See page 10 for auto fill
instructions.
5. Prime the pump as per instructions on page 10.
6. Adjust the pressure to 500psi. See instructions on
page 11.
7. Chemical will draw only in the "LOW" pressure
setting of your pressure gun. To activate the "LOW"
pressure setting, pop the collar of the gun out.
8. In "LOW" pressure, apply chemical to the walls and
fixtures starting from the lowest point to the highest.
9. Spray the floor as you make your way out of the
room.
10. Allow the chemical time to dwell according to the
chemical manufacturers recommendations.
11. You may use a brush to agitate particularly soiled
areas.
12. When you are ready to rinse away the chemical,
pull the collar of your 9000AC "IN", to activate high
pressure rinse mode. If you require a higher volume
of flow for rinse mode, you may bypass the 991RS
chemical injector system by connecting your 25ft
hose directly to the male quick connect on the EN-
DEAVOR's control panel.
13. Rinse surfaces starting from the top and working
your way down.
14. Use a 334ACH squeegee wand to extract the excess
fluid from the floor.
15