dji 650 H1 TRV EFT Посібник із швидкого старту - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Дрони dji 650 H1 TRV EFT. dji 650 H1 TRV EFT 18 сторінок.
Друкувати сторінку
10. Flight
Ready to Go (GPS)
In the DJI GO 4 App
Auto Takeoff
The aircraft will take off and hover at
an altitude of 4 feet (1.2 meters).
Return-to-Home (RTH)
Brings the aircraft back to the Home
Point. Tap again to stop the procedure.
More Intelligent Flight Modes
Tap to use TapFly (P-mode), ActiveTrack (P-mode) and more.
Watch the tutorial in the DJI GO 4 app or on the official DJI website to learn more.
Always set an appropriate RTH altitude before takeoff. Refer to the Disclaimer and Safety Guidelines for more details.
Manual Takeoff
Combination Stick Command to start/stop the motors
Return-to-Home (RC)
Same as the RTH button in the DJI GO 4 app. Brings the aircraft
back to the Home Point.
Press and hold to initiate the RTH procedure. Press again to cancel.
Determine RTH status by sound:
Single beep... Request to return, but not receive the respond
from the aircraft yet.
Double beep... RTH in progress.
Rotating propellers can be dangerous. DO NOT start the motors in narrow spaces or
when there are people nearby.
Always keep your hands on the remote controller so long as the motor is still spinning.
After landing, power off the aircraft before turning off the remote controller.
Take off from a flat surface in a wide open space, with the rear of the aircraft facing
towards you.
The intelligent landing gear will auto raise after takeoff and lower when landing.
Users can also control the landing gear manually by the Transformation Switch.
The aircraft will not be able to land if the landing gear does not lower.
Aircraft Status Indicator
. . . Ready to go (GPS working).
. . . Vision System on, GPS off or unavailable.
. . . P-ATTI or ATTI mode.
..... Not connected to remote controller.
Before taking off, ensure that the Aircraft Status Bar in the DJI GO 4 app
indicates 'Ready to Go (GPS)' or 'Ready to Go (Vision)' in flying indoors.
or
Auto Landing
The aircraft will land vertically and stop its
motors.
Gimbal Working Modes
Includes Tracking Mode, Free Mode and
Reset Mode.
Manual Landing
1. Ensure the landing gear is lowered
before landing.
Left stick up
(slowly) to take off
2. Pull left stick down (slowly)
until you touch the ground.
Hold a few seconds to stop
the motors.
. . . Low battery warning.
..... Critically low battery warning.
—— Critical error.
. . . Compass calibration required.
Raise
Lower
Stop motor mid-flight: Press the RTH
button while simultaneously pulling
the left stick to the bottom inside
corner and hold for 3 seconds. Only
stop motors mid-flight in emergency
s i t u a t i o n s w h e n d o i n g s o c a n
reduce the risk of damage or injury.
9