FiTech 50019 Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Водяний насос FiTech 50019. FiTech 50019 6 сторінок. Go fuel in-tank retrofit kit
Друкувати сторінку6. Measure depth of tank and
determine where pump needs to
be positioned vertically (Figure 7.)
Once you have determined proper
pump location so that filter sock
will be within an 1/8" of the bottom
of the tank when installed, cut the
opaque hose and metal support
rod to the desired length (Figure 8
& 9.) Using a heat gun, heat the
end of the hose that will go onto
the fuel pump (Figure 14). Push
the heated hose onto the outlet
nipple of the pump.
to push straight and evenly. Do
not force as pump nipple can
break. If hose is not fully on pump
nipple, reheat hose prior to
pushing further.
Secure with a hose clamp. (Item
10)
7. Determine the correct length of
the black return hose. It should be
long enough to be about 1/4" off
the bottom of the tank. Cut hose
at a 45-degree angle.
8. Locate the pump against the
support bracket and secure into
position with two Tie Wraps (Items
15). Make sure Tie Wraps are
pulled tight. See Figure 16. Plug
the electrical connector onto the
fuel pump.
Figure 10
Note: Be sure
(Figure 17)
9. Insert Pump Assembly into tank. Lower down
over the threaded rods and use 1/4-20 nuts to hold
module into place. (Figure 10)
10. Install allen bolts with sealing washers into the
open 10 holes. Remove the two threaded rods and
install the last two allen bolts. Tighten securely
using a crisscross pattern to tighten module down
evenly.
Figure 7
Figure 8
Figure 9
5