dji AGRAS MG-1S Інструкція з експлуатації Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Дрони dji AGRAS MG-1S. dji AGRAS MG-1S 17 сторінок. Spreading systems
Також для dji AGRAS MG-1S: Посібник із швидкого старту (20 сторінок)
Друкувати сторінку
Maintenance
1. Clean the residue inside the spread tank and spreader regularly. It is recommended to use dry
compressed air and a clean, soft dry cloth. DO NOT rinse with liquids.
2. The spinner disk is a consumable part. If obvious signs of wear are noticeable, follow the steps
below to replace the spinner disk.
a. Make sure that the aircraft is powered off, and then unplug the Spreading System cable.
b. To unlock the spreader, pull the spreader lock knob out, rotate it 90°, and release. Then
rotate the spreader to detach it.
2
1
3
c. Remove the nut, washer, four M3×8 screws, and spinner disk at the bottom of the spreader.
Mount a new spinner disk and secure it using the washers, M3×8 screws, and nut.
d. Check the spreader lock knob is in an unlocked position. Insert the spreader with the knob
located to the left of the circular indentation on the spread tank.
e. Rotate the spreader to mount it to the spread tank. To lock the spreader, pull the spreader
lock knob out, rotate it 90°, and release. Make sure that the spreader is locked in position.
8
© 2020
DJI All Rights Reserved.
Lock
Spinner Disk
Washer
M3×8 Screws
Nut
3
2
1
Unlock