dji AGRAS MG-1S RTK Посібник із швидкого старту - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Дрони dji AGRAS MG-1S RTK. dji AGRAS MG-1S RTK 20 сторінок.

Installation

Threadlocker is required for installation. Apply threadlocker when mounting the landing gear, spray tank, sprinklers

and power port modules. Ensure threadlocker is totally dry and solid before flight.

DO NOT bend the hose in an arc tighter than its minimum bend radius during installation. This is to avoid creasing, which

may compromise the spraying effect.

Ensure that all installation and connection procedures are completed before powering on the aircraft.

Installation steps are the same for both the MG-1S and MG-1S RTK.

The illustrations below use the MG-1S as an example.

Mounting the Hose Clip

Mount the self-adhesive hose clip to the outside of the right landing gear

leg mounting position (as shown) and tighten the M3×6 screw.

1. Identify the landing gear leg containing the two compass cables.

2. Take out each compass cable from the tube of the landing gear leg. Looking from the rear of the aicraft, connect

each compass cable to the compass port on the right side of the aircraft body. Put the assembled cable into the

cable protector slot and close it. Be careful not to damage the cable.

3. Place each cable protector and cable into its corresponding mounting position on the aircraft body then mount

the right landing gear leg to the mounting position.

4. Insert the two anti-drop plates into the mounting position and tighten the three M3×10 screws.

Aircraft Rear

Cable Protector

Compass Port

Compass Cable

5. Mount the left landing gear leg and tighten the three M3×10 screws.

Mounting the Power Port Modules

Mount the two power port modules on the bottom of the aircraft onto the two landing gear legs and tighten the

two M3×18 screws and one M3×22 screw.

M3×18

M3×22

AGRAS MG-1S

Anti-drop Plates

Mounting to the upper screw hole

M3×18

Quick Start Guide