EDIC-mini CARD24S Посібник з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Обладнання для запису EDIC-mini CARD24S. EDIC-mini CARD24S 8 сторінок.

Recorder's Operation Modes

Notes:

Pressing the button twice - briefly press the button twice within two seconds.

Pressing the button three times - shortly press the button three times within 3 seconds.

Single pressing of two buttons - press and release both buttons simultaneously, so that they are pressed

simultaneously.

Standby Mode:

When none of the functions of the Recorder is activated, the Recorder is in Standby mode, and there is no LED

indication.

Install/Remove Memory Card

Insert memory card into the slot by pressing it with a little effort (press again to remove the memory card).

The Recorder will automatically check the card, and if it is operational, formatted and suitable for recording,

there will be a short flash of the red LED (the LED flashes during card initialization time; as a rule, this process

takes several seconds).

If the red LED starts flashing frequently (indicating card error), remove the card, wait until the LED stops

flashing, and then reinstall the card.

If the above procedure did not help and the LED continues to flash frequently, that means the card is not

operational, not formatted, or not suitable for recording. In this case, remove the card and check it on any

other device, and if necessary the card can be formatted.

After a single short pressing of the REC button, the Recorder switches from Standby mode to Record mode,

and there is a short flash of the red LED. After that the Recorder starts recording. During recording, the red

LED indicates operating mode in two series of flashes.

The first series of LED flashes corresponds to battery charge level and the second to free memory capacity.

The interval between the first and second series of flashes is 3 seconds, and between the second and first 7

seconds.

The dependence of the number of flashes on the battery charge level, or on the amount of free memory is

shown in the following table:

Number of flashes

To stop recording, press the REC button once. Red LED will be on to indicate recording has stopped.

Battery charge level (1st

series)

80-100%

20-80%

2-20%

Free memory capacity (2nd

series)

75-100%

50-75%

25-50%

1-25%