Arthrex Synergy Resection AR-8315W Посібник оператора - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник оператора для Перемикач Arthrex Synergy Resection AR-8315W. Arthrex Synergy Resection AR-8315W 20 сторінок. Wireless footswitch

Друкувати сторінку

4. Locate the Pairing Buttons on the footswitch and receiver.

A. The AR-8315W Wireless Footswitch's GFS/SFS Mode button is located

below the center of the handle (see Figures 3 & 4). The footswitch's

Pairing Button is also located below the handle, adjacent to the GFS/SFS

Mode Button (see Figure 4).

B. The AR-8315W Wireless Receiver's Pairing Button is located behind the

wireless symbol near the bottom of the receiver (see Figure 2).

Figure 3

II.

5. Simultaneously press and hold both Pairing Buttons and release them when the

RED Battery LED begins flashing rapidly (10% duty cycle @ 1Hz).

A. Only a simultaneous press and hold of the Pairing Buttons will initiate the

pairing process and it will complete within 11 seconds.

B. All buttons and pedals on the footswitch are ignored during this process.

6. Once the pairing process is completed, the RED Battery LED should either:

A. Turn OFF if pairing was successful,

B. Flash slowly (50% duty cycle @ 1Hz) if pairing was unsuccessful, or

C. Flash rapidly for the remainder of the pairing process, then flash slowly if

no footswitch is found

7. If pairing is unsuccessful, repeat steps 1-5, paying particular attention to the

NOTE in step 1 and to step 3.

8. Following a successful pairing operation, normal footswitch operation will not

begin until the footswitch is positioned horizontally. Consult the User Guide for

the shaver console and/or AR-8315W footswitch for more information if needed.

9. The RED Battery LED on the receiver will turn on if the paired footswitch has a

low battery condition (Total Battery Voltage is <=2.0V). The only way to clear a

Low Battery condition is to cycle footswitch power by removing and re-installing

batteries with a total voltage >2.0V and press a pedal or button on the footswitch.

It is not necessary to pair the footswitch and receiver again.

DFU-0320-3 Rev. 0

II.

GFS/S FS Mode Button

Pairing Button

Figure 4

10 of 20