FiTech 40003 Інструкція з монтажу - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Блок управління FiTech 40003. FiTech 40003 4 сторінки. Fuel command center
Друкувати сторінку
Roots type Superchargers Only:
Plug the indicated vacuum port with a #10-32
set screw which will thread directly into the
hole. Use Red Loctite to seal the threads. Con-
nect boost reference hose to 3/16" nipple "A"
For Unblown or Blow-through Only:
Use nipple for boost gauge or boost reference.
Use zip-tie to retain hose on nipple.
Figure 2
Plug all unused
fuel ports.
INLET
Figure 4
LEFT - The FiTech Go EFI Throttle Body has (3) Inlet Ports and (1) Return
Port. The Return Port is plugged when using the Fuel Command Center.
IMPORTANT NOTE: The fuel tank on your ve-
hicle must be vented to avoid pressure build-
ing up inside the tank. Do not attempt to
install and operate an EFI system without a
properly vented fuel tank.
FiTech
Fuel Injection
RETURN
INLET
INLET
T
Figure 3
0-15 Inlet Fuel
Pressure Gauge
Float Adjust-
ment Screw
Inlet
Fuel Pressure
Regulator
Sump Tank Component of
Fuel Command Center
Fuel Delivery System
Figure 5
FiTech Fuel Injection
12370 Doherty Street • Riverside, CA 92503
Tech Phone: 951-340-2624
www.FiTechEFI.com
0-100 Outlet Fuel
Pressure Gauge
Electrical
Terminals
Vent
Outlet
Complete Command
Center Kit #40003 shown.