Akku Power 7S2P Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для Аксесуари для фотоапаратів Akku Power 7S2P. Akku Power 7S2P 14 сторінок. Li-ion dt2 battery, 25.2v / 9.0/5.0ah / 226.8/126wh, idex fire & safety
Також для Akku Power 7S2P: Інструкція з техніки безпеки (12 сторінок)

Друкувати сторінку
LED Code Summary
LED
LED
Description
combination
comb. no.
10
Undervoltage
16
Load Overcurrent
1 (>52A for 5s)
17
Load overcurrent 2
(>156A for 160ms)
18
Charge
overcurrent
19
Short circuit
20
Temperature
not OK
8
Description
Action
Battery voltage is
If battery is not charging after 5 minutes and charger is indicating defective
battery please contact your IDEX Fire & Safety technical service.
too low / completely
empty
Current consumption
Wait until the error code is gone (min. 30s). Check the battery function using
another tool.
between battery and
If the error persists with second tool contact your dealer otherwise check the
tool is temporarely
first tool to exclude its defect.
too high
Current consumption
Check battery on another tool and after minimum 30 sec the error should be
gone.
between battery and
If the error persists with the second tool contact your dealer otherwise send in
tool is temporarely
the first tool for a technical revision.
too high
Charging current
Check battery on another charger and after minimum 30 sec the error should
too high
be gone
If the error persists with the second charger contact your dealer otherwise
send in the first charger for a technical revision
Power consumption
Be sure that „+ / -"contacts are not directly in contact via conducting materials.
Wait for at least 30 sec until the error should be gone, then check the battery
too high – higher
in another tool.
than the overload
If the battery error code occurs in second tool please contact your dealer´s
current
technical service for assistance.
Cell and FETs
First adjust the Cells temperature by disconnecting or stop operating the
temperature
battery in order to let the battery cool down or warm up until it reaches the
is outisde the
maximum or minimum allowed temperature
recommend
Later if the battery is still blocked test the battery in another tool to test if the
temperature range
the error persists.
If the battery error code occures in second tool please contact your dealer´s
technical service for assistance.
7